Instant Takeoff, Built Into OneCrew

The Problem

Takeoffs are one of the most time-consuming parts of estimating.

• Manually measuring from imagery
• Switching between mapping tools and spreadsheets
• Re-entering quantities into estimating software

Even when the numbers are accurate, the process slows everything down.

What This Changes

Instant Takeoff is now embedded inside OneCrew.

You can generate measurements directly from site imagery and move straight into estimating without leaving the platform.

• No exporting.
• No re-entry.
• No disconnected steps.

How It Works

Map entire sites in seconds and turn them into estimates without leaving OneCrew.
‍
Inside OneCrew:

• Open a project and click into Maps
• Select Detect with TruTec
• Highlight the area and choose what you want to measure
• TruTec analyzes the imagery and generates areas, lines, and counts
• Use those measurements directly in your estimate

Why It Matters

• Move faster from site to estimate Generate takeoffs in minutes instead of manually measuring
• Increase bid capacity Handle more work without adding estimating headcount
• Keep everything connected Measurements flow directly into estimates, proposals, and execution
• Reduce errors and rework No manual transfer of quantities between tools

Why It Works Better Inside OneCrew

Most takeoff tools stop at measurement.
Inside OneCrew, the takeoff becomes part of the workflow.

The same mapped project carries through:
Estimate → Proposal → Schedule → Field Execution → Job Cost

Your team works off the same scope from start to finish.